HDPE waterproofing membrane products do a good job of keeping your house dry and tidy, it’s one of several good solutions for leaking houses because it’s affordable, it’s low maintenance, and it’s really very convenient.

Whether it’s a leaking roof or possibly a room leaking to another level of occupants, it can damage to property as well as neighborhoods. It is a ubiquitous architectural phenomenon, and in construction, leaking water may be the second biggest overuse injury in building quality. Now, many people have taken measures, waterproof coatings, waterproof membranes, and other products.

Exactly what are HDPE damp membranes?

HDPE damp membranes are in fact a self-adhesive waterproof material, containing the functions of superior performance, hot temperature resistance, and sturdiness. In addition, the self-adhesive film features a polymer adhesive layer.

HDPE damp membranes are made from high-quality high-density polyethylene resin, at the same time frame, ultraviolet absorbers, anti-aging agents, etc. can also be used.

Features of HDPE waterproof membrane

Durable

Long-lasting

Less maintenance

Supports construction on wet bases

Easy to construct

Castable skeleton steel bar

It could form a super-strong bond with concrete, thus preventing the penetration of rain and moisture

Able to walk

As soon as the waterproof layer is fully gone, it could be directly linked with the effect resistance of reinforced concrete with out a protective layer

Low requirements for that lower layer, and can be constructed on uneven and wet base surfaces

Not suffering from objective factors, thereby reducing construction costs

More flexible construction methods

Good waterproof performance

Widely application

Be it the rooftop the main ramp, the waterproofing of the tunnel, as well as the pool, it can be perfectly waterproofed. At the same time, HDPE damp membranes bring high-requirement waterproof projects and some gas leakage prevention.

Installation tips

Maintain the first layer clean first. In the event the sharp the main protrusion is located, it’ll be processed to become flat. Should there be more water stains, maintain your lower layer moist.

Unroll the membrane. When laying the film around the first layer, you need to take notice of the particles in the film facing up, and also the edges present in adjacent films have to be aligned to avoid overlapping.

The best way to determine the thickness in the film meets what’s needed?

Using this method is incredibly brief, have a needle and randomly select 3 points per 100 square meters for the membrane for penetration experiments. Dimensional measurements were created to the thickness with the 3 needle punches respectively, and finally, an average value was taken for his or her heights. If the average thickness is bigger than 1.5mm, it meets the requirements.

More information about màng hdpe take a look at this web page